Page 1 of 2
Minor Rant
Posted: Thu Nov 02, 2017 8:51 am
by Art Haberland
I hate sanding...
that is all
Re: Minor Rant
Posted: Thu Nov 02, 2017 10:20 am
by lustyslogger
Art Haberland wrote:I hate sanding...
that is all
LOL
Re: Minor Rant
Posted: Thu Nov 02, 2017 10:52 am
by Charlie P. (NY)
Nothing like hours of sanding over your head while leaning in under a hull.
What fun.
I miss the days I could have been a fill in for Uncle Hunchback Smurf.
Re: Minor Rant
Posted: Thu Nov 02, 2017 11:00 am
by Michel
I don't paint so I don't sand!

Re: Minor Rant
Posted: Thu Nov 02, 2017 12:44 pm
by lustyslogger
Michel wrote:I don't paint so I don't sand!

What??????
How can you claim to be a sailor and not sand??
When I was in the Navy on board ship we did not sand - we chipped. Then we painted, then we chipped what we just painted.
Every 6 months or so we would remove all the paint from the main deck and then paint it again. Then we chipped.
See a pattern here?
Re: Minor Rant
Posted: Thu Nov 02, 2017 1:53 pm
by Michel
Re: Minor Rant
Posted: Fri Nov 03, 2017 7:09 am
by lustyslogger
I don't use antifouling either. I do the same with the brush. I have a curved handle on my brush and I have taped a large plastic bottle to the brush end of the handle. That way it floats up against the bottom of the boat. I mostly have a algae issue but I just saw an ad by Exxon I think that they are going to use algae to make fuel. Maybe I could start collecting it and selling it to them to offset my sailing expenses!
Re: Minor Rant
Posted: Fri Nov 03, 2017 10:53 am
by Art Haberland
lustyslogger wrote:
When I was in the Navy on board ship we did not sand - we chipped. Then we painted, then we chipped what we just painted.
Every 6 months or so we would remove all the paint from the main deck and then paint it again. Then we chipped.
See a pattern here?
If you can't polish it, Paint it, if you can't paint it, Salute it.
my sanding:
Getting the cabin ready for some two part epoxy primer before painting it.
Re: Minor Rant
Posted: Wed Nov 08, 2017 10:34 am
by PAR
I find beer helps "change my models" enough to make sanding an acceptable chore. Time wise, it's likely about 70% of a small boat build, if done to a moderately good finish. If you're going to put this much time and elbow pain into it, you should at least have a reasonable buzz.
Re: Minor Rant
Posted: Wed Nov 08, 2017 11:59 am
by Art Haberland
All well and good Par, but as a Buddhist I don't drink. I have to suck it up and take it like the suffering all life is
