Scamp #337 - Novice, Plans Build (Formally "Introducing")

The place to discuss SCAMP (Small Craft Advisor Magazine Project), our 11' 11" micro minicruiser.

Moderator: Moderator

GregWads
Regular Contributor
Posts: 83
Joined: Thu Sep 03, 2015 9:58 am
Location: NWbyW Illinois
Contact:

Re: Scamp #337 - Novice, Plans Build (Formally "Introducing"

Post by GregWads »

After dry fitting the frames the centerboard gap appears to be larger on the aft end.
CBgapFrwd.jpg
CBgapFrwd.jpg (36.46 KiB) Viewed 1865 times
While traveling through Chattanooga TN, earlier this year, I stopped and picked up roughly 48 board feet of air dried, 4 quarters, rough-sawn, Cypress to use for the cleats, carlins and centerboard slot end posts. Using my table saw as a thickness planer leaves me with material between 7/8 inch and 1 inch thick (depending on the board.) Hence the reason the posts are two pieces to get the required inch and half.
CBslotRearGap.jpg
CBslotRearGap.jpg (35.24 KiB) Viewed 1865 times
Post Reply

Who is online

Users browsing this forum: Google [Bot] and 23 guests